![]() When repairing the chassis, do not make the high voltage exceed 27.5KV (The beam current is 0uA). The CRT anode high voltage has been adjusted and set in the factory. When replacing the resister with high power, keep it over the PCB about 10mm. Keep the wires away from the components with high temperature or high voltage. When fuse blow, ensure to replace a fuse with the same type and specification. Discharge of CRT anode should be done only to CRT ground strap. Portions of the power supply board are hot ground. All specification must be met over line voltage ranger of 160V AC to 240V AC 50Hz/60Hz. ![]() Only qualified personnel should perform service procedures. So, to avoid the risk of electric shock, be careful to adjust the chassis! 1. Servicing Precautions When working, the unit is with ultra high voltage about 25KV inside. TCL Chassis M35&36 Service Manual 1 03.Mar.2003 SERVICE MANUAL FOR M35&36 CHASSIS PART I.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |